Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | TPU / flexible ASA 20% | TPU / flexible ASA 40% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| No printable model files are available for an estimate yet. | ||||||
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
rod hood support for honda and other cars
Shared by
3DPrintedCarPartDescription
This thing is the part that supports the rod that holds open the hood of a car. It was designed to fit Honda civics but it most likely will fit any other vehicle make. This thing needs to be printed in a semi-flexible material or it will be very difficult to affix to the car engine compartment holder and the rod won't fit comfortably either. I printed it on flexible PLA which is a ok material for this use but it gets softer with engine temperature. It has been in place for the last 5 months with no issues but I hope it will be better if you can get a plastic a little more firm.
Compatible Cars
Originally published on thingiverse.com by Youguess It (LostBullet) · License: CC BY-NC
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
