Tesla Model 3 Trunk Hook Extended - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Trunk/Tailgate

Tesla Model 3 Trunk Hook Extended

0 downloads37 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

Remix of Motorpixiegimbals's threaded trunk hook. Extended it by 2cm at the stem to better accommodate access to the hooks. The bottom of the hooks have slightly problematic overhangs, so I enabled supports from build plate. I also printed this using adaptive layer heights to improve layer adhesion on some of the object interface points, while also maintaining a reasonable print time. While normally I'd recommend PETG for anything that has to endure the heat that can build up in a car trunk, I printed it with PLA+ (Inland) and used it throughout the summer without issue.