Tesla Model 3 Trunk spring cover - image

Files (6)

Shoulder_Washer.3MF

3MF

49.0 KB

Shoulder_Washer.STEP

STEP

32.2 KB

Shoulder_Washer.STL

STL

158.3 KB

Spring_Cover.3MF

3MF

32.4 KB

Spring_Cover.STEP

STEP

31.8 KB

Spring_Cover.STL

STL

122.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

6 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 100%	100% solid	Recommendation
Shoulder_Washer.3MF	Printable file	49.0 KB 3MF	Slice file	Slice file	Slice file	Print the shoulder washer at 100% infill for strength
Shoulder_Washer.STEP	Printable file	32.2 KB STEP	Slice file	Slice file	Slice file	Print the shoulder washer at 100% infill for strength
Shoulder_Washer.STL	Printable file	158.3 KB STL	Slice file	Slice file	Slice file	Print the shoulder washer at 100% infill for strength
Spring_Cover.3MF	Cover / cap	32.4 KB 3MF	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.
Spring_Cover.STEP	Cover / cap	31.8 KB STEP	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.
Spring_Cover.STL	Cover / cap	122.9 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Trunk/Tailgate

Tesla Model 3 Trunk spring cover

0 downloads23 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a cover to mask the trunk spring when you install an automatic trunk lifter on your Tesla Model 3. The cover is in two pieces, the cover placed at the bottom and the shoulder washer placed at the top. You must align the water evacuation hole at the bottom after installation. To print the shoulder washer is very easy, i advise you to print it in ABS at 100% infill and 0.25mm layer, 0.4mm nozzle. To print the cover, I advise you to print the firsts 3mm at 100% infill, 0.25mm layer, 0.4mm nozzle and print the lasts mm in vase mode with a 0.5mm wall width, 0.25mm, 0.4mm nozzle layer for a better quality.