Tesla Model 3 trunk storage loop extension 20mm finger hole - image

Files (2)

REMIX_loop_extension.STL

STL

257.6 KB

REMIX_loop_extension_cap.STL

STL

183.5 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
REMIX_loop_extension.STL	Printable file	257.6 KB STL	Slice file	Slice file	Slice file	Ensure a tight fitting cap by adjusting the design if necessary
REMIX_loop_extension_cap.STL	Cover / cap	183.5 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Trunk/Tailgate

Tesla Model 3 trunk storage loop extension 20mm finger hole

0 downloads30 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Remix of Tesla Model 3 trunk storage loop extension by jonco223. * 20 mm finger hole instead of 25 mm * Tighter fitting cap. SLDPRT files included if you need to adjust fit of cap.