Tesla Model S console insert (pre-refresh) - image

Files (4)

coinRamp.stl

STL

45.2 KB

mainBox.stl

STL

726.6 KB

rollTopInsert.stl

STL

2.8 KB

rollTopLid.stl

STL

187.5 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

4 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG 20%	PETG 25%	100% solid	Recommendation
coinRamp.stl	Printable file	45.2 KB STL	Slice file	Slice file	Slice file	Ensure proper fit and orientation in the slicer to avoid supports if possible
mainBox.stl	Printable file	726.6 KB STL	Slice file	Slice file	Slice file	Ensure proper fit and orientation in the slicer to avoid supports if possible
rollTopInsert.stl	Accessory piece	2.8 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
rollTopLid.stl	Printable file	187.5 KB STL	Slice file	Slice file	Slice file	Ensure proper fit and orientation in the slicer to avoid supports if possible

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Center Console

Tesla Model S console insert (pre-refresh)

0 downloads28 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a centre console for a Model S designed for my needs - might not fit yours:) The insert contains a large section for sunglasses, a section to hold gum, a "roll top" section for "stuff", a place to drop loose change and a place at the very rear for charging cards. When you print the main box, you can slide the rolltop in (when printed in PETG its flexible enough), the fit the coin ramp in to seal the end. No glue, or supports required - but you might need to play the rolltop in and out a few times to clear the channels. I added some cushioning on the bottom of the large section to help protect sun glasses, used a little bit more down the side to wedge the insert in place. In my car - the roll top section is printed in black and looks better for it, I've put in a red one for the photos so its easier to see.