Toyota Gen 1 Hilux/Tacoma/4Runner/T100 Dash Switch Cover preview

Files (1)

toyota_switch_cover_improved_blank.stl

STL

2.1 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	ABS / ASA 20%	ABS / ASA 25%	100% solid	Recommendation
toyota_switch_cover_improved_blank.stl	Cover / cap	2.1 MB STL	Slice file	Slice file	Slice file	Use ABS / ASA; check sealing faces and verify in slicer, but likely needed when printing on its side.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Toyota Gen 1 Hilux/Tacoma/4Runner/T100 Dash Switch Cover

0 downloads10 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

ABS or ASA

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer, but likely needed when printing on its side

Infill

20-30% infill for strength, with 2-3 walls

Difficulty

Not rated — inspect geometry

Vehicle heat

Higher-heat material; verify location and load

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This is a dashboard switch-hole cover plate for various older Toyota trucks and SUVs. The original came from the other thingi site, item number 2446920 by bgsteveg. I improved it by adding some gussets to keep the tabs from cracking off. Two additional STLs are included that have cutouts for one or two KCD11 rocker switches. This enables the use of inexpensive switches for automotive use. This should be printed in ABS, ASA, or some other high-temp plastic, since it would get soft and saggy at high temperatures in a truck cabin. I printed this face down with no supports from ABS, however I recommend this be printed on its side with supports to make the print a little stronger at the base of the tab. I added a photo of the essentially identical Toyota OEM part for comparison. Feel free to remix, modify, and enjoy this model! I gave this a CC-Attribution license so that the original creator gets credit where credit is due.