Toyota Rav4 Reverse Camera 2006 - 2012 - image

Files (5)

Camera_Mount_1.stl

STL

112.9 KB

Camera_Mount_2.stl

STL

173.5 KB

Middle.stl

STL

323.7 KB

Side_A.stl

STL

49.2 KB

Side_B.stl

STL

49.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

5 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Camera_Mount_1.stl	Mount / bracket	112.9 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports
Camera_Mount_2.stl	Mount / bracket	173.5 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports
Middle.stl	Printable file	323.7 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports
Side_A.stl	Printable file	49.2 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports
Side_B.stl	Printable file	49.2 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Exterior

Toyota Rav4 Reverse Camera 2006 - 2012

0 downloads35 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I designed this mount to mount the camera in the center of the vehicle so the parking lines would line up. I used a cheap camera set up from amazon. Camera mounts to the underside of the 3rd brake light using using longer screws in the stock location. The camera clears the rear wiper and has survived an automatic carwash. I used 3mm hardware to secure it toughener but sure you could use a SAE equivalent.