Toyota Tacoma center console tray preview

Files (1)

tacoma_tray_v3.1.stl

STL

217.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
tacoma_tray_v3.1.stl	Primary model	217.2 KB STL	Slice file	Slice file	Slice file	Print with a brim for stability

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Toyota Tacoma center console tray

0 downloads10 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA

Print time

Slice to calculate

Filament

Slice to calculate

Supports

supports likely

Infill

20-30% infill for durability, with 2-3 outer walls

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

Note that this will fit 2024+ Tacomas only! The Tacoma has a lot of space in its center console, but it's deep relative to its width; a tray insert makes it a lot more usable. You could buy a similar part, but why buy when you can print? Main bins are 50 mm deep: a good size for a flashlight, pens, tire pressure gauge, or whatever else you need quick access to. Includes slots for a few coins and a shallow tray area. Recommend printing in PETG or another filament with good heat resistance; PLA probably can't stand up to inside temperatures on a hot day. Supports required for the outer flange.