Toyota Tacoma Phone Holder (Note 10+ Sized) - image

Files (3)

Tacoma_Phone_Clip_Rib-WIDER.stl

STL

64.7 KB

Tacoma_Phone_Mount.stl

STL

276.1 KB

Tacoma_Phone_Mount_Lowered.stl

STL

284.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Tacoma_Phone_Clip_Rib-WIDER.stl	Clip	64.7 KB STL	Slice file	Slice file	Slice file	Ensure the print bed is level and clean for optimal adhesion
Tacoma_Phone_Mount.stl	Mount / bracket	276.1 KB STL	Slice file	Slice file	Slice file	Ensure the print bed is level and clean for optimal adhesion
Tacoma_Phone_Mount_Lowered.stl	Mount / bracket	284.8 KB STL	Slice file	Slice file	Slice file	Ensure the print bed is level and clean for optimal adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Toyota Tacoma Phone Holder (Note 10+ Sized)

0 downloads30 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Dashboard Mount for a Toyota Tacoma - Note 10 Plus Sized (With Case) -Standard Mount sits above the dash allowing All Infotainment controls to be accessed. -Lowered Mount is Lowered but will Block Air vent and Stereo buttons a little bit, but to me it feels more sturdy.