Umbrella Holder - VW Tiguan Anchor Point - image

Files (1)

Umbrella_Holder.stl

STL

722.9 KB

Print guidance estimate

Uses saved filament metadata

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

50g

Based on 25% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG / ASA

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Umbrella_Holder.stl	Mount / bracket	722.9 KB STL	46g $1.10	50g $1.20	110g $2.63	Print two holders for a standard setup

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Umbrella Holder - VW Tiguan Anchor Point

0 downloads612 views0 likes

Shared by

Michael Chen

Verified

Description

This umbrella hook can hold a single umbrella on the back of the rear seats of a VW Tiguan (and maybe other cars). Print two and clip each holder into the anchor points in your car (see photos). Note: This design is based loosely on urst13's "Umbrella Holder", see Umbrella Holder for Backseats Note: Use PLA for locations where summer temperatures are not too high. PETG would be better suited when summer temperatures reach 35°C or higher.