2010 Ford Expedition Cup Holder Insert preview

Files (1)

Ford Expedition Cup Holder Insert.stl

STL

2.2 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 30%	100% solid	Recommendation
Ford Expedition Cup Holder Insert.stl	Mount / bracket	2.2 MB STL	Slice file	Slice file	Slice file	Print with the top plate against the bed for optimal results

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

2010 Ford Expedition Cup Holder Insert

0 downloads77 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for better heat resistance

Print time

Slice to calculate

Filament

Slice to calculate

Supports

supports unlikely

Infill

20-40% infill with 2-3 walls for sufficient strength and weight reduction

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY-SA

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This is a removable insert for the front dual cup holder in a 2010 Ford Expedition. My rubber one went missing, so I designed a replacement. Printed with the top plate against the bed, no supports are needed as bridging is suffice. For a better quality print, I suggest slowing your bridge speeds down, this will result in a better/tighter finish on the inside of the cup holder base, and make it easier to wash out when needed. I printed at 4 walls and 70% infill (because I use PLA and I wanted it to have more material to withstand the summer heat), but in hindsight, that was extreme overkill.