Center Caps for Enkei RPF1 wheels - 73mm - image

Files (4)

CenterCap_5mm.STL

STL

1.4 MB

CenterCap_Batman.STL

STL

1.5 MB

CenterCap_RallyPig.STL

STL

2.9 MB

CenterCap_STI.STL

STL

1.4 MB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

4 model files

Typical selected file

48g

Based on 25% main infill for the largest likely-needed model file

Material cost

$1.15

Filament only at roughly $24/kg PETG / ASA

Print time

1.4h–2.3h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
CenterCap_5mm.STL	Cover / cap	1.4 MB STL	32g $0.77	35g $0.83	76g $1.82	Use PETG / ASA; check sealing faces and verify in slicer.
CenterCap_Batman.STL	Cover / cap	1.5 MB STL	33g $0.80	36g $0.87	79g $1.90	Use PETG / ASA; check sealing faces and verify in slicer.
CenterCap_RallyPig.STL	Cover / cap	2.9 MB STL	44g $1.06	48g $1.15	105g $2.53	Use PETG / ASA; check sealing faces and verify in slicer.
CenterCap_STI.STL	Cover / cap	1.4 MB STL	32g $0.78	35g $0.84	77g $1.85	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Emblems/Badges

Center Caps for Enkei RPF1 wheels - 73mm

0 downloads32 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a center cap designed to fit on Enkei RPF1 wheels. They may be able to fit other wheels with the same size hub as well. Test fitted and worked on: Enkei 17x9 RPF1 (Silver) Wheels/Rims 5x100 (3797908045SP) There are a few different files with different image designs. 1) Blank 2) STI emblem 3) Rally Pig emblem 4) Batman symbol Feel free to request other image designs! Note: a few people reported having scaling issues when importing into their slicer. If the scaling seems way off, your slicer may have imported the STL assuming the incorrect units (designed in English units, not metric). Try changing the units to english in your slicer if you can, otherwise you can try scaling by 2540% to get the conversion factor.