Jeep Camera Mount, Bull Bar Mount, Pipe Clamp Mount - image

Files (1)

Pipe_Clamp.stl

STL

57.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Pipe_Clamp.stl	Primary model	57.8 KB STL	Slice file	Slice file	Slice file	Ensure a secure fit on the bull bar by adjusting the clamp's position and tightening the 1/4-20 screws

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Front Bumper

Jeep Camera Mount, Bull Bar Mount, Pipe Clamp Mount

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I wanted to be able to put a small camera (like a backup camera) on the front bumper of my Jeep. The camera will allow me to see what is in front of me when I crest a hill (other than looking at sky out of the windshield). I made this clamp that holds the camera and can be installed and removed quickly when I am at the trail-head. Uses 6-32 screws to hold the camera. Uses 1/4-20 screws to clamp to the bumper bull bar.