Tesla Model 3 Wheel Cap for measuring ride height - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Exterior

Tesla Model 3 Wheel Cap for measuring ride height

0 downloads30 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

V002 I added a separate plug that does two things: in vertical orientation, it makes it easier to make an exact mark on your fender. In horizontal orientation, it's an exact contact point that sits at wheel axle height. Furthermore, I found my own caps hard to remove, and the bigger hole helps - you can pop in a screwdriver and lever it out. I lowered my car with a ride height adjustable suspension, and needed to measure ride height accurately. Rather than take an educated guess as to where the wheel center is, I decided to print 4 of these dummy wheel caps, so I could find the center more easily. This design is based on 3D Math's Tesla Model 3 Wheel center cap. I shamelessly stole the dimensions and the snap features, and made my own markings on the front.