SAAB 9-3 Washer Fluid Reservoir Cap Dual extrusion - image

Files (3)

Cap1.stl

STL

399.7 KB

Cap2.stl

STL

281.5 KB

Ring.stl

STL

998.1 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Cap1.stl	Cover / cap	399.7 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.
Cap2.stl	Cover / cap	281.5 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.
Ring.stl	Printable file	998.1 KB STL	Slice file	Slice file	Slice file	Print with the flat top facing the print bed to minimize support needs

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

SAAB 9-3 Washer Fluid Reservoir Cap Dual extrusion

0 downloads36 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I did a remix to be able to either replace the logo with whatever or print it with extruder 2 using another color. It worked out nicely. Also it is possible to print the cap itself with the flat top now facing the print bed. That way, it doesn't need support at all. When I printed the cap on the picture, Ironing was enabled in Cura.